No verified model list is available for this code
A manufacturer code/support source may be available, but no exact supported model has been documented for this record. Do not treat the code as a model-specific diagnosis without checking the manual.
Verify the full model number against the manufacturer manual.
Open manufacturer sourceWhat does this code mean?
Turbidity sensor fault. The exact model manual determines applicability; a fault code alone does not prove a particular component is defective.
Source scope: Compatibility with specific model numbers has not been established. Always check your exact appliance manual.
The manufacturer lists this code and general meaning; compatibility with your exact model has not been verified. Follow your model manual.
Open manufacturer sourceWhat can you try?
- 01
Record the exact code and when it appeared
Note every letter and digit, the stage of the cycle and the full model label. Error meanings can vary between models.
What the result means: This prevents applying guidance for a different model or a similar-looking code.
- 02
Rule out visible user-level obstructions
Look only at accessible vents, doors, filters or exterior hoses mentioned in your manual. Never access wiring, motors or control boards.
What the result means: No visible obstruction means a code does not establish a specific failed part.
- 03
Verify once, then stop repeated attempts
If there is no safety hazard and your model manual permits it, test one normal cycle after the checks. If the same error returns, report the code and actions already tried.
What the result means: A recurring code does not identify a failed component by itself.
Stop immediately for leaks, smoke, burning smell or electrical danger. For gas leaks, leave the area and call local emergency services.
How do you actually fix this?
Start with safe checks. Some codes have no safe home fix; in that case we explain what the professional repair actually involves.
Practical fixes you can try
- Check the surrounding conditions first: are doors or air outlets blocked, or is there unusual heat or steam affecting the sensed environment?
- Clean only accessible surfaces and user filters as the manual allows. Never bridge a sensor, unplug an internal connector or spray liquid onto it.
- Do not force a higher setpoint or run repeated long tests if the sensor warning remains.
If it persists, how is it actually repaired?
A technician compares the sensor reading and wiring with model service values, distinguishes open/short circuits from board faults, and repairs only the confirmed sensor or connection.
How do you know it is fixed? The readings should return to normal with no recurring sensor error.
Safety and warranty: Warranty terms depend on manufacturer, model and local law. Damage caused by unauthorised disassembly or improper repair may be excluded. Live electrical work, gas, refrigerant circuits and sealed cabinets require qualified professionals; this is not a DIY instruction for those tasks.
Evidence: The manufacturer link above supports the broad code meaning. The repair pathway is a general technical diagnostic explanation, not a confirmed failed-part diagnosis for every model.
Manufacturer source
Independent safety-focused explanation with a manufacturer link. Possible causes are not verified part diagnoses; the code may vary by model or region.
Open original manufacturer guidance ↗