No verified model list is available for this code
A manufacturer code/support source may be available, but no exact supported model has been documented for this record. Do not treat the code as a model-specific diagnosis without checking the manual.
Verify the full model number against the manufacturer manual.
Open manufacturer sourceWhat does this code mean?
Boiling protection. The exact model manual determines applicability; a fault code alone does not prove a particular component is defective.
Source scope: Compatibility with specific model numbers has not been established. Always check your exact appliance manual.
The manufacturer lists this code and general meaning; compatibility with your exact model has not been verified. Follow your model manual.
Open manufacturer sourceWhat can you try?
- 01
Record the exact code and when it appeared
Note every letter and digit, the stage of the cycle and the full model label. Error meanings can vary between models.
What the result means: This prevents applying guidance for a different model or a similar-looking code.
- 02
Check for overheating before any test
Do not force open a hot appliance. If there is steam, smoke, burning smell or a leak, do not run a test cycle or open the heater compartment.
What the result means: Potential overheating means stop and request service.
- 03
Try only a manual-approved restart once
If there are no signs of heat, water or electrical danger, use the restart process in your model manual once. Note whether the error reappears at heating.
What the result means: Repeated heating faults require professional measurement.
Stop immediately for leaks, smoke, burning smell or electrical danger. For gas leaks, leave the area and call local emergency services.
How do you actually fix this?
Start with safe checks. Some codes have no safe home fix; in that case we explain what the professional repair actually involves.
Practical fixes you can try
- Confirm the selected program actually calls for heat and that the target temperature was not accidentally reduced. No warmth in the first minutes does not by itself prove a failure.
- For dishwashers, check the model’s inlet-water temperature limit. For a dishwasher, keep its user filter clean and ensure the spray arm is not blocked.
- Stop for persistent no-heat, unexpected overheating or burning smells. Do not open heaters, thermostats or control boards.
If it persists, how is it actually repaired?
A technician compares sensor readings, heater circuit and control commands against service specifications and repairs the confirmed heater, sensor or control fault.
How do you know it is fixed? The cycle should reach its intended temperature/drying level without overheating or repeating the fault.
Safety and warranty: Warranty terms depend on manufacturer, model and local law. Damage caused by unauthorised disassembly or improper repair may be excluded. Live electrical work, gas, refrigerant circuits and sealed cabinets require qualified professionals; this is not a DIY instruction for those tasks.
Evidence: The manufacturer link above supports the broad code meaning. The repair pathway is a general technical diagnostic explanation, not a confirmed failed-part diagnosis for every model.
Manufacturer source
Independent safety-focused explanation with a manufacturer link. Possible causes are not verified part diagnoses; the code may vary by model or region.
Open original manufacturer guidance ↗