No verified model list is available for this code
A manufacturer code/support source may be available, but no exact supported model has been documented for this record. Do not treat the code as a model-specific diagnosis without checking the manual.
Verify the full model number against the manufacturer manual.
Open manufacturer sourceWhat does this code mean?
Circulation pump or pressure issue. The exact model manual determines applicability; a fault code alone does not prove a particular component is defective.
Source scope: Compatibility with specific model numbers has not been established. Always check your exact appliance manual.
The manufacturer lists this code and general meaning; compatibility with your exact model has not been verified. Follow your model manual.
Open manufacturer sourceWhat can you try?
- 01
Confirm the code and exact model
Check whether the display says F14/F69 and note the model number. Miele says a circulation pump may stick after long periods unused in some machines.
What the result means: Other faults may produce the same code; the exact model guide takes precedence.
- 02
Prepare safely
Switch off and allow the cabinet to cool. Only where your manual allows, remove the lower spray arm and filter assembly. Never access internal electrical or pump components.
What the result means: Do not work in hot water: scalding is possible.
- 03
Use the Miele warm-water method only if approved
For an applicable model, Miele describes around 1 litre of warm water plus 3–5 drops of rinse aid in the wash cabinet. Never use boiling water; the manufacturer specifies a maximum of 75°C. Allow about 5 minutes.
What the result means: This may release a pump stuck after a long idle period; it does not establish which part failed.
- 04
Refit, run and monitor
Securely replace the filter and lower spray arm, then restart a normal programme. Miele permits 2–3 repetitions if needed. Stop for unusual noise, leakage or continuing errors.
What the result means: Persistent faults may require a qualified Miele technician to check pump-pressure or control components.
Stop immediately for leaks, smoke, burning smell or electrical danger. For gas leaks, leave the area and call local emergency services.
How do you actually fix this?
Start with safe checks. Some codes have no safe home fix; in that case we explain what the professional repair actually involves.
Practical fixes you can try
- Stop the appliance. Check that crockery does not block an accessible spray arm.
- Clean an accessible spray arm only as your manual permits.
- Stop retries if there is a burning smell, grinding noise, severe vibration or recurring motor error.
If it persists, how is it actually repaired?
A technician distinguishes mechanical seizure, drive faults, motor electronics and wiring using the service procedure and repairs the confirmed defect.
How do you know it is fixed? The motor should complete its normal cycle without unusual noise or the same warning.
Safety and warranty: Warranty terms depend on manufacturer, model and local law. Damage caused by unauthorised disassembly or improper repair may be excluded. Live electrical work, gas, refrigerant circuits and sealed cabinets require qualified professionals; this is not a DIY instruction for those tasks.
Evidence: The manufacturer link above supports the broad code meaning. The repair pathway is a general technical diagnostic explanation, not a confirmed failed-part diagnosis for every model.
Manufacturer source
Independent safety-focused explanation with a manufacturer link. Possible causes are not verified part diagnoses; the code may vary by model or region.
Open original manufacturer guidance ↗