TREN
Search codes
Hotpoint · Dishwasher

Hotpoint Dishwasher F10: Heating element fault

On supported Hotpoint dishwasher models, F10 may indicate heating element fault. Verify your exact model before diagnosis.

ERROR CODEF10Verify the model and regional series

Model compatibility has not been independently verified

Earlier archive data contained suggested model or series names. Without a clear model/code table in a manufacturer manual, these names are no longer displayed as verified matches.

This is general brand/device guidance; check the model label and official manual.

Open manufacturer source

What does F10 mean?

On supported Hotpoint dishwasher models, F10 may indicate heating element fault. Verify your exact model before diagnosis.

Source and model applicability: Hotpoint Birleşik Krallık ankastre bulaşık makineleri; LED gösterim ve model değişebilir

Manufacturer document consulted

Üretici hata kodu listesi ile genel anlam eşleştirildi; tek tek model/seri uyumu ayrıca doğrulanmadı. The manufacturer lists common families; no single specific model was validated for this entry.

View official manufacturer source

Safe checks to try

  1. 01

    Record the exact error and model

    Observation only

    Record Hotpoint F10, the full model label and the cycle/mode. Manufacturer meaning: Heating element fault. Check that the published source applies to your series.

    What to look for: The exact model prevents using instructions for a different appliance family.

  2. 02

    Record heating symptoms

    Observation only

    Note whether heating is weak or overheating occurs. Stop if smoke or burning smell appears.

    What to look for: This distinguishes heating and protection behavior.

  3. 03

    Check load and ventilation

    Observation only

    Use a manual-approved load and keep visible air intakes clear.

    What to look for: A persistent issue requires a heater/control check.

For a qualified service technician

An authorized technician should assess the component associated with 'Heating element fault' and verify the relevant signals and protections against the exact model service manual. Internal electrical and refrigerant work is not suitable for home repair.

Do not open electrical panels, sealed refrigerant lines, gas connections, heating elements or powered mechanisms at home.

After the issue is addressed

Confirm that F10 no longer appears during the normal user cycle. Retest according to the exact model manual; if it reappears, stop and contact authorized support.

Manufacturer references

Region and model family vary. These source links are not proof of compatibility with every Hotpoint appliance.