No verified model list is available for this code
A manufacturer code/support source may be available, but no exact supported model has been documented for this record. Do not treat the code as a model-specific diagnosis without checking the manual.
Verify the full model number against the manufacturer manual.
Open manufacturer sourceWhat does this code mean?
Electrolux associates iC2 with electronic control / communication; the faulty component cannot be confirmed from the code alone.
Manufacturer guidance is model/type dependent. The code alone does not identify a failed part.
The exact code and primary meaning appear in manufacturer documentation. Scope: Üreticinin belirttiği cihaz türü / desteklediği model ailesi. Individual parts and all models are not verified.
Open manufacturer sourceWhat can you try?
- 01
Record the code and exact appliance model
Photograph iC2 as displayed and record the full model number from its label. Electrolux may use different meanings for the same characters on other products.
What the result means: Do not treat a generic code as proof of a failed component.
- 02
Safely restart the control system once
Electrolux describes isolating power for one minute for the iC0–iC3 group when safe. Never touch wet or damaged electrical parts.
What the result means: Do not repeat resets if the code reappears.
- 03
Check accessible filter and sump
With the appliance off and cool, clean user-accessible food debris or suds according to the manual. Do not open electrical controls.
What the result means: Persistent codes can require control-system inspection.
- 04
Escalate with useful details
Give support the exact iC2 display, full model, when it appeared and safe checks completed. Do not run the unit with smoke, leakage, burning smell or breaker trips.
What the result means: A service technician must test the suspected component rather than guessing from the code.
Stop immediately for leaks, smoke, burning smell or electrical danger. For gas leaks, leave the area and call local emergency services.
How do you actually fix this?
Start with safe checks. Some codes have no safe home fix; in that case we explain what the professional repair actually involves.
Practical fixes you can try
- Photograph the code and note any preceding outage or moisture exposure. Stop if plugs or wiring appear damaged.
- Only if your manual explicitly permits and there is no gas, water, heat or smoke hazard, try one normal restart. Do not keep resetting a persistent fault.
- Do not open boards, relays, wiring or internal fuses; hazardous energy may remain even after switch-off.
If it persists, how is it actually repaired?
A technician checks supply, connections and the affected board output; distinguishes a wiring/load fault from the board itself, then repairs or replaces the proven defective module with required configuration.
How do you know it is fixed? The affected function and safety interlocks must work through a complete cycle with no repeat fault.
Safety and warranty: Warranty terms depend on manufacturer, model and local law. Damage caused by unauthorised disassembly or improper repair may be excluded. Live electrical work, gas, refrigerant circuits and sealed cabinets require qualified professionals; this is not a DIY instruction for those tasks.
Evidence: The manufacturer link above supports the broad code meaning. The repair pathway is a general technical diagnostic explanation, not a confirmed failed-part diagnosis for every model.
Manufacturer source
Independent safety-focused explanation with a manufacturer link. Possible causes are not verified part diagnoses; the code may vary by model or region.
Open original manufacturer guidance ↗