No verified model list is available for this code
A manufacturer code/support source may be available, but no exact supported model has been documented for this record. Do not treat the code as a model-specific diagnosis without checking the manual.
Verify the full model number against the manufacturer manual.
Open manufacturer sourceWhat does this code mean?
Electrolux groups this code with dishwasher heating problems. The code alone does not prove which component is faulty.
Source scope: Electrolux i60/i61/i69/i6C ısıtma kod grubu Always check your exact appliance manual.
This code and broad meaning appear in manufacturer support material. Applicability to your exact model is not yet proven. Confirm your full model designation in the official manual.
Open manufacturer sourceWhat can you try?
- 01
Confirm inlet water temperature
Electrolux advises that incoming water should not exceed 60°C for this code family. Do not test hot water by touch; ask a qualified person if you cannot safely confirm the setting.
What the result means: Overheated inlet water can require a supply correction, not an automatic part replacement.
- 02
Follow the one-minute power-off step
Only if there is no leak, burning smell or electrical hazard, stop the dishwasher. Isolate power at a safe accessible plug or breaker, wait about one minute and reconnect. Do not pull out a built-in unit.
What the result means: If it starts normally, the error may have been temporary.
- 03
Observe one normal program and stop if it recurs
Record whether the same code returns and whether water is heating properly. If it does, contact Electrolux with the PNC/model and code instead of repeating resets.
What the result means: Heating components and internal electronics require professional testing.
Stop immediately for leaks, smoke, burning smell or electrical danger. For gas leaks, leave the area and call local emergency services.
How do you actually fix this?
Start with safe checks. Some codes have no safe home fix; in that case we explain what the professional repair actually involves.
Practical fixes you can try
- Electrolux additionally specifies inlet water not above 60°C for this code family and a one-minute power-off check where safe.
- Confirm the selected program actually calls for heat and that the target temperature was not accidentally reduced. No warmth in the first minutes does not by itself prove a failure.
- For dishwashers, check the model’s inlet-water temperature limit. For a dishwasher, keep its user filter clean and ensure the spray arm is not blocked.
- Stop for persistent no-heat, unexpected overheating or burning smells. Do not open heaters, thermostats or control boards.
If it persists, how is it actually repaired?
A technician compares sensor readings, heater circuit and control commands against service specifications and repairs the confirmed heater, sensor or control fault.
How do you know it is fixed? The cycle should reach its intended temperature/drying level without overheating or repeating the fault.
Safety and warranty: Warranty terms depend on manufacturer, model and local law. Damage caused by unauthorised disassembly or improper repair may be excluded. Live electrical work, gas, refrigerant circuits and sealed cabinets require qualified professionals; this is not a DIY instruction for those tasks.
Evidence: The manufacturer link above supports the broad code meaning. The repair pathway is a general technical diagnostic explanation, not a confirmed failed-part diagnosis for every model.
Manufacturer source
Independent safety-focused explanation with a manufacturer link. Possible causes are not verified part diagnoses; the code may vary by model or region.
Open original manufacturer guidance ↗