Bosch F27: Pressure sensor fault

No verified model list is available for this code

A manufacturer code/support source may be available, but no exact supported model has been documented for this record. Do not treat the code as a model-specific diagnosis without checking the manual.

Verify the full model number against the manufacturer manual.

Open manufacturer source

What does this code mean?

Bosch identifies F27/E27 as a pressure sensor error; internal repair is not a user task.

Manufacturer guidance is model/type dependent. The code alone does not identify a failed part.

Code meaning matched manufacturer source

The exact code and primary meaning appear in manufacturer documentation. Scope: Üreticinin belirttiği cihaz türü / desteklediği model ailesi. Individual parts and all models are not verified.

Open manufacturer source

What can you try?

01
Record the code and exact appliance model
Photograph F27 as displayed and record the full model number from its label. Bosch may use different meanings for the same characters on other products.
What the result means: Do not treat a generic code as proof of a failed component.
02
Do not attempt sensor repair
Bosch identifies F27/E27 as a pressure sensor fault and says it cannot be user-repaired. Stop the appliance and contact support with the exact model.
What the result means: Do not dismantle or attempt to calibrate the pressure sensor.
03
Escalate with useful details
Give support the exact F27 display, full model, when it appeared and safe checks completed. Do not run the unit with smoke, leakage, burning smell or breaker trips.
What the result means: A service technician must test the suspected component rather than guessing from the code.

Stop immediately for leaks, smoke, burning smell or electrical danger. For gas leaks, leave the area and call local emergency services.

PRACTICAL FIX / REPAIR

How do you actually fix this?

Start with safe checks. Some codes have no safe home fix; in that case we explain what the professional repair actually involves.

Practical fixes you can try

Check the tap, visible drain hose and excessive foam first. A level-sensor code does not prove whether the fault is in a pump, valve or sensor.
If the level rises abnormally, close the water tap and avoid electrical connections on a wet floor.
Only clean a user-accessible filter if the manual says so. Do not remove cabinets to reach pressure tubing or level sensors.

If it persists, how is it actually repaired?

A technician compares the real water level with the sensor reading, checks pressure passages and valve/pump commands, and clears a proven blockage or repairs a confirmed sensor fault.

How do you know it is fixed? Filling and draining must return to normal without the level warning.

Safety and warranty: Warranty terms depend on manufacturer, model and local law. Damage caused by unauthorised disassembly or improper repair may be excluded. Live electrical work, gas, refrigerant circuits and sealed cabinets require qualified professionals; this is not a DIY instruction for those tasks.

Evidence: The manufacturer link above supports the broad code meaning. The repair pathway is a general technical diagnostic explanation, not a confirmed failed-part diagnosis for every model.

Manufacturer source

Independent safety-focused explanation with a manufacturer link. Possible causes are not verified part diagnoses; the code may vary by model or region.

Open original manufacturer guidance ↗