No verified model list is available for this code
A manufacturer code/support source may be available, but no exact supported model has been documented for this record. Do not treat the code as a model-specific diagnosis without checking the manual.
Verify the full model number against the manufacturer manual.
Open manufacturer sourceManufacturer meanings by device / model family
A code may mean different things on different products. Check the device type and manual scope for each entry.
- Zeolit/CrystalDry donanımlı Bosch bulaşık makineleri; model belirtilmemiş: Zeolite chamber heater fault; only for models with this system — Manufacturer source
Do not open electrical components, gas or refrigerant circuits; consult qualified service.
What does this code mean?
Bosch US documents E10 as a Zeolite/CrystalDry chamber heater fault; not all Bosch models contain this system. Verify the appliance E-Nr.
Manufacturer guidance is model/type dependent. The code alone does not identify a failed part.
Bosch US documents E10 as a Zeolite/CrystalDry chamber heater fault; not all Bosch models contain this system. Verify the appliance E-Nr.
Open manufacturer sourceCheck Bosch US listWhat can you try?
- 01
Record the exact code and when it appeared
Note every letter and digit, the stage of the cycle and the full model label. Error meanings can vary between models.
What the result means: This prevents applying guidance for a different model or a similar-looking code.
- 02
Rule out visible user-level obstructions
Look only at accessible vents, doors, filters or exterior hoses mentioned in your manual. Never access wiring, motors or control boards.
What the result means: No visible obstruction means a code does not establish a specific failed part.
- 03
Prepare precise notes for the technician
Provide the code, model number, stage of the program, sounds and any leak. Avoid opening a warranty-covered appliance or authorizing replacements without diagnosis.
What the result means: A technician can test components rather than guessing from the code.
Stop immediately for leaks, smoke, burning smell or electrical danger. For gas leaks, leave the area and call local emergency services.
How do you actually fix this?
Start with safe checks. Some codes have no safe home fix; in that case we explain what the professional repair actually involves.
Practical fixes you can try
- Confirm the selected program actually calls for heat and that the target temperature was not accidentally reduced. No warmth in the first minutes does not by itself prove a failure.
- For dishwashers, check the model’s inlet-water temperature limit. For a dishwasher, keep its user filter clean and ensure the spray arm is not blocked.
- Stop for persistent no-heat, unexpected overheating or burning smells. Do not open heaters, thermostats or control boards.
If it persists, how is it actually repaired?
A technician compares sensor readings, heater circuit and control commands against service specifications and repairs the confirmed heater, sensor or control fault.
How do you know it is fixed? The cycle should reach its intended temperature/drying level without overheating or repeating the fault.
Safety and warranty: Warranty terms depend on manufacturer, model and local law. Damage caused by unauthorised disassembly or improper repair may be excluded. Live electrical work, gas, refrigerant circuits and sealed cabinets require qualified professionals; this is not a DIY instruction for those tasks.
Evidence: The manufacturer link above supports the broad code meaning. The repair pathway is a general technical diagnostic explanation, not a confirmed failed-part diagnosis for every model.
Manufacturer source
Independent safety-focused explanation with a manufacturer link. Possible causes are not verified part diagnoses; the code may vary by model or region.
Open original manufacturer guidance ↗