No verified model list is available for this code
A manufacturer code/support source may be available, but no exact supported model has been documented for this record. Do not treat the code as a model-specific diagnosis without checking the manual.
Verify the full model number against the manufacturer manual.
Open manufacturer sourceWhat does this code mean?
Water level not rising. The exact model manual determines applicability; a fault code alone does not prove a particular component is defective.
Source scope: Compatibility with specific model numbers has not been established. Always check your exact appliance manual.
The manufacturer lists this code and general meaning; compatibility with your exact model has not been verified. Follow your model manual.
Open manufacturer sourceWhat can you try?
- 01
Record the exact code and when it appeared
Note every letter and digit, the stage of the cycle and the full model label. Error meanings can vary between models.
What the result means: This prevents applying guidance for a different model or a similar-looking code.
- 02
Check the home water supply
Open a nearby tap. If water is unavailable, resolve the supply issue before blaming the appliance. If water flows normally, check that the appliance inlet valve is open.
What the result means: No water at the tap suggests a home supply issue.
- 03
Rule out visible user-level obstructions
Look only at accessible vents, doors, filters or exterior hoses mentioned in your manual. Never access wiring, motors or control boards.
What the result means: No visible obstruction means a code does not establish a specific failed part.
- 04
Prepare precise notes for the technician
Provide the code, model number, stage of the program, sounds and any leak. Avoid opening a warranty-covered appliance or authorizing replacements without diagnosis.
What the result means: A technician can test components rather than guessing from the code.
Stop immediately for leaks, smoke, burning smell or electrical danger. For gas leaks, leave the area and call local emergency services.
How do you actually fix this?
Start with safe checks. Some codes have no safe home fix; in that case we explain what the professional repair actually involves.
Practical fixes you can try
- Check the tap, visible drain hose and excessive foam first. A level-sensor code does not prove whether the fault is in a pump, valve or sensor.
- If the level rises abnormally, close the water tap and avoid electrical connections on a wet floor.
- Only clean a user-accessible filter if the manual says so. Do not remove cabinets to reach pressure tubing or level sensors.
If it persists, how is it actually repaired?
A technician compares the real water level with the sensor reading, checks pressure passages and valve/pump commands, and clears a proven blockage or repairs a confirmed sensor fault.
How do you know it is fixed? Filling and draining must return to normal without the level warning.
Safety and warranty: Warranty terms depend on manufacturer, model and local law. Damage caused by unauthorised disassembly or improper repair may be excluded. Live electrical work, gas, refrigerant circuits and sealed cabinets require qualified professionals; this is not a DIY instruction for those tasks.
Evidence: The manufacturer link above supports the broad code meaning. The repair pathway is a general technical diagnostic explanation, not a confirmed failed-part diagnosis for every model.
Manufacturer source
Independent safety-focused explanation with a manufacturer link. Possible causes are not verified part diagnoses; the code may vary by model or region.
Open original manufacturer guidance ↗